Characterization of the iPhone LiDAR[…] https://pmc.ncbi.nlm.nih.gov/articles/PMC10537187/pdf/sensors-23-07832.pdf
So we know it is a 60hz, 940nm infrared signal. We also know that it can be expected to present as a rotating pattern of lattice grid beams of light. Armed with this information, I began brainstorming different approaches to measuring such a signal in a meaningful way. It was at this point that I realized I actually don't really know how to do that, so I looked it up.
LiDAR is a Flashy Light, How Do We Measure a Flashy Light
After a lot of web searching, reading other researchers' existing work, reading a lot of Wikipedia pages, struggling to get good suggestions out of LLMs, and poring over datasheets, I reached a point where I felt I was beginning to understand the objectives well enough.
See a signal as light spread into beams over an area
Sense and convert that light to an analog signal
Convert the signal from analog to digital
Measure it
The iPhone TrueDepth uses a 60hz, 940nm VCSEL DotGrid Lattice LiDAR system. In order to detect this and distinguish it from other signal sources, a device would need to sense IR signals from multiple discrete sources at high speed from which several factors could be measured. Once these factors are measured, the device would need to be able to quickly perform calculations on the measurements and programmatically decide whether the measured signals are the desired target, or noise. The factors we would want to measure are signal frequency, pulse repetition frequency, whether the signal is steady or in bursts, and how many sensors detect the same signal at the same time or not.
Now, armed with even more information I set about looking up what components might suit the needs of the project.
Hardware
This device needs to detect 940nm infrared signals. I tested several ways to accomplish this, including LEDs wired as photodiodes with and without 940nm bandpass filters, pin silicon photodiodes with and without bandpass filters, and 940nm peak pin silicon photodiodes. While LEDs wired as photodiodes were surprisingly effective, the cleanest and clearest signals were obtained using 940nm peak photodiodes.
In addition to just detecting 940nm infrared signals, the device needs to be able to discern a signal's apparent frequency. We know that the iPhone LiDAR is flashing at 60hz, so we need to be able to detect a 60hz signal, and probably harmonics of that same frequency up to some reasonable amount. This aspect of the target is where either having a 940nm peak photodiode, or using a bandpass filter really comes in handy. Most displays around you are going to be at 30, 60, or 120hz and in my testing I found that without filtering for the desired wavelength almost any display would trigger a false positive.
In order to process this signal, we need to perform operations at a high speed. Solutions for the sensors, like pin silicon photodiodes and fast components like 10mhz op-amps or schmitt triggers, work just fine for capturing these signals and making them available. To process them the device needs to strike a fair compromise between energy consumption and processing power. These days, there are countless tiny little chips that fit this bill. Since I already had development boards laying around, I chose the SAMD21 for its 48mhz processor and tiny energy footprint. Using this chip as the platform to build on, I went through several iterations of hardware designs.